+607-2870 393
+601110688201


EC Instruments & Engineering Sdn Bhd
46, Jalan Seri Austin 3/55,
Taman Seri Austin,
81100 Johor Bahru,
Johor, Malaysia.
+607-2870393
EC Instruments & Engineering
Pte Ltd
6, Penjuru Place,
#01-31,2-8 Penjuru Tech Hub,
Singapore 608781.
+65-96312280
+65-67740200
terry@ecinstruments.net
+6596312280

Ipoh Office
29, Laluan Bg Perdana 20, Taman Batu Gajah Perdana, 31550 Pusing, Perak, Malaysia.
sales@ecinstruments.net
+60166021123

Pump control EPS-MT

Previous 1 / 6 Next

Pump control EPS-MT Pressure Switch TIVAL SENSORS


Download Files

EPS_MT_Electronic_Pump_Control.pdf (518.25 KB)
  • Booster stations
  • Domestic waterworks
  • Garden pumps
  • Sprinkle irrigation units

The electronic pump control EPS-MT combines the function of both mechanical pressure switch and flow-control (dry running protection) in one unit.
The EPS-MT controlsand protects AC-powered pumps convincingly. The application range is limited to pumps with a max. pressure of up to 10 bar,
for higher operating pressures a pressure-reducing regulator has to be installed on the intake side.The readiness for operation is indicated
by a green LED. Failures are displayed by a red LED.
Directly after connection to the electrical power supply the pump will start automatically and the EPS-MT will immediately take over the control function. If the piping system is under pressure, but no flow is detected, the EPS-MT will cut off the pump after a short time delay.
If the system pressure decreases below the preadjusted start-up pressure (factory setting 1,5 bar) the pump will restart. In case of no pressure and flow is detected after the pump restart, the EPS-MT will identify this status within short time as „dry running“ and switch off the pump.
At frequent intervals of 60 minutes the pump control automatically checks for sufficient amount of water in the system.
If enough water is detected, the EPS-MT will reset to normal operating modus. After four repeating attempts without sufficient water in the system
the pump control finally performs the troublecode „dry-running“ and must then be resetted manually.
The system pressure is displayed by the integrated bolt-on manometer.

 

Please leave your enquiry here, we will reply as soon as possible.
Name*  
Company Name  
Product Interested  
Quantity  
Email*  
Contact No.*  
Ship to Name  
Shipping Address  
Attachment  
*only support gif, jpeg, jpg, png, pdf
Messages*  

Switch to Mobile Version
Subscribe Newsletter